Baldwin Estate Hinge Replacement Screw Size Guide
Share
If you are replacing a missing or damaged screw in a Baldwin Estate door hinge, start with the hinge model and the material the hinge is fastened to. Baldwin lists different screws for wood doors and jambs than for tapped metal doors or frames.
Baldwin Estate hinge replacement screw sizes
| Baldwin Estate hinge | Wood door and wood jamb | Tapped metal door or frame |
|---|---|---|
|
1030 3-inch square corner 1035 3-1/2-inch square corner 1135 / 1435 3-1/2-inch radius corner 1140 / 1440 4-inch radius corner |
#10 × 1-inch Flat-head Phillips undercut wood screw |
#10-24 × 1/2-inch Flat-head Phillips machine screw for supported 1030 and 1035 applications |
|
1040 / 1041 4-inch square corner 1045 / 1046 4-1/2-inch square corner 1051 5-inch square corner |
#12 × 1-1/4-inch Flat-head Phillips undercut wood screw |
#12-24 × 1/2-inch Flat-head Phillips machine screw |
Important: Match the substrate as well as the hinge model. Wood screws are not interchangeable with the machine screws used in tapped metal. Also compare the original screw's head diameter and countersink before installation.
Buy one matching-size brass wood screw
For wood-door applications where solid brass is appropriate, Classic Door sells individual flat-head Phillips solid-brass wood screws with no minimum order and free shipping:
- #10 flat-head Phillips solid-brass wood screw — choose the 1-inch length.
- #12 flat-head Phillips solid-brass wood screw — choose the 1-1/4-inch length.
These are nominal-size solid-brass alternatives, not Baldwin factory screw packs. Solid brass is softer than steel. Predrill the hole, tighten by hand at the end, and confirm that brass is suitable for the door weight and application.
How to identify the right replacement
- Find the Baldwin model number or measure the hinge height and corner style.
- Determine whether the screw enters wood or a threaded metal hole.
- Compare an undamaged original screw for gauge or thread, length, drive, head diameter, and finish.
- Test that the replacement sits fully flush before closing the door.
A screw head that stands above the hinge leaf can cause the hinge to bind. A screw with the wrong thread can damage a tapped metal hole.
Not sure which Baldwin screw you need?
Send clear photos of the hinge, the screw hole, and one remaining original screw if available. Include the hinge size, model number, and whether the screw goes into wood or metal.
Order help finding a Baldwin replacement screw
Shop solid-brass screws for hinges
Frequently asked questions
What screw fits a Baldwin 1035 hinge?
For a Baldwin Estate 1035 hinge fastened to wood, Baldwin lists a #10 × 1-inch flat-head Phillips wood screw. A supported tapped-metal application uses a #10-24 × 1/2-inch flat-head Phillips machine screw.
What screw fits a Baldwin 1040 hinge?
For a Baldwin Estate 1040 hinge fastened to wood, Baldwin lists a #12 × 1-1/4-inch flat-head Phillips wood screw. A tapped-metal application uses a #12-24 × 1/2-inch flat-head Phillips machine screw.
Can I use a solid-brass screw in a Baldwin hinge?
A same-size solid-brass wood screw may provide a closer decorative finish match, but it is softer than steel. Treat it as a fit-tested alternative, not an automatic structural substitute.
Does Classic Door sell one Baldwin hinge screw?
Classic Door sells individual solid-brass wood screws with no minimum order and free shipping. If the specification is uncertain, the Baldwin replacement-screw identification service can help locate the closest available match.